Factory-direct manufacturer · Xiamen, China · Exporting worldwide

Temperature Sensors & Transmitters

TPT10 Integrated Temperature Transmitter

4–20 mA, 2-wire

Request a quote

TPT10 technical data

Measurement

Range
−200 to +600 °C, to customer specification
Element
Pt100, Pt1000 and similar
Accuracy class
0.1 or 0.2
Non-linearity
0.2
Hysteresis
Better than 0.01 % of span

Electrical

Supply voltage
DC 24 V (12–36 V)
Output
Two-wire 4–20 mA; three-wire 1–5 V
Load impedance
750 Ω
Insulation resistance
≥ 100 MΩ at 100 V DC

Mechanical

Probe length
To customer specification
Probe diameter
8 mm standard, others to order
Probe material
Stainless steel
Process connection
G1/2″, M20×1.5 or to order
Ambient temperature
−20 to +60 °C
Ambient humidity
< 85 %
Ingress protection
IP65

Values are for the standard configuration. Ranges, threads, probe lengths and output types outside this table are available on request — the datasheet revision for a custom build is issued with the quotation.

Request the PDF datasheet →

Temperature Sensors & Transmitters

TPT10Integrated Temperature Transmitter

4–20 mA, 2-wire

Pt100 probe with an integrated transmitter in the head, giving a two-wire 4–20 mA signal directly from the sensor. −200 to +600 °C, 0.1 or 0.2 accuracy class, epoxy-potted and intrinsically safe module, IP65.

Engineering reply · Evaluation samples available · Custom ranges built to order

  • Two-wire 4–20 mA straight from the head — no long RTD leads
  • Epoxy-potted: vibration and humidity resistant
  • Intrinsically safe transmitter module
  • Accuracy class 0.1 or 0.2
  • Reverse-polarity and short-circuit protection

How it works

The TPT10 puts the transmitter on the probe rather than in the panel. The element's resistance is linearised, protected against supply reversal, and converted to a two-wire 4–20 mA current in the head, so the cable run carries a signal that does not pick up resistance error from long leads. The module is epoxy-potted, which is what makes it survive vibration and humidity in a plant room, and it is an intrinsically safe design for hazardous areas. Accuracy class is 0.1 or 0.2, and the probe length is made to your requirement.

Typical applications

  • Long cable runs where RTD lead resistance would matter
  • Hazardous areas needing an intrinsically safe loop
  • Retrofit of bare RTD probes without a panel transmitter

Not certain TPT10 is the right unit?

Send the medium, range, process connection and the signal your control system accepts. We will confirm the model — or tell you which one fits better — before you commit to an order.

Same family

Other temperature instruments

View the family →